Topic: DIP Switch on FMC150 Board  (Read 4987 times)

Juergen October 22, 2013, 12:53 PM

  • Member
  • *
  • Posts: 15
Hello
 
According to the schematics of FMC150 r2.1 (see http://www.4dsp.com/forum/index.php/topic,2161.0.html) there is a Dip Switch J17 for controlling WP/CDCE_MODE/CDCE_AUX settings, but I am not able to locate the switch on the board. So my questions are:   
  • Is J17 populated on r2.1?
  • Can you provide me with an assembly plan of r2.1?
Thank you,
Juergen

arnaudNL October 23, 2013, 03:58 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Juergen,


No J17, is not populated the complete chip configuration is done by a software through the firmware during run time.


We don't have an assembly plan as soldering/modifying the board will void the warranty.


Best Regards,
Arnaud

CKristof December 17, 2013, 11:31 AM (#2)

  • Member
  • *
  • Posts: 1
Dear Arnaud,
What happens if these pins are short-circuitted? Is it possible,
to drive CDCE_MODE low, and enable configuration default on
CDCE this way? (Supposing there is no connection of the pin on LPC)
regards
Chris

arnaudNL December 17, 2013, 11:39 AM (#3)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Hello Chris,


The FMC150 operation modes are given by the FMC150 user manual. Any soldering on the PCB will void the warranty.


Best Regards,
Arnaud

arnaudNL December 18, 2013, 11:24 AM (#4)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.