These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: Getting Started with ML605 and FMC30RF  (Read 3846 times)

kcfarleyswmacb October 01, 2013, 01:14 PM

  • Member
  • *
  • Posts: 45
What are the steps to get up and running with ML605 board and FMC30RF.  I've been going through "4FM Getting Started Guide" and haven't found the simple steps to get up and running with the ML605 and FMC30RF combo?
  • Logged

Kyu October 02, 2013, 11:55 AM (#1)

  • Member
  • *
  • Posts: 154

Hi,


Please refer chapter 8 in the 4FM getting started guide. It describes how you can run a reference design.


Thanks,
Kyu
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016