Topic: How to transfer data from FMC116 to PC directly?  (Read 3072 times)

Xun Wu September 03, 2013, 05:47 PM

  • Member
  • *
  • Posts: 14
 Hello everyone,
I have a FMC116 board and a VC707 FPGA board. I have interfaced the FMC116 to VC707. I used a chipscope to observe the samples sampled from a sinusoidal wave and the results showed that the FMC116 worked very well.
The next thing I need to do is to retrieve data from FMC116 and write the data into a file (like a text file or data file) on PC, just like what is done when evaluating the FMC116 with the reference design. But I don’t know how to transfer data from FMC116 to the PC directly. Could anyone give me some help?
Sincerely Yours,

arnaudNL September 04, 2013, 04:00 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,

Our reference design acquire samples through a data wormhole. These packets are transferred over Ethernet to the host computer. The software running on the host computer is creating the files.

I assume this is what you need to implement on your firmware. This should be achievable as you have the whole firmware source code and the software source code.

Best Regards,