These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: refence firmware - output folder  (Read 3944 times)

mahturk January 29, 2014, 06:28 AM

  • Member
  • *
  • Posts: 7
Hello,


When i installed my licensed firmwave (ml605+fmc104), i see that the output folder in the extracted firmwave top folder is empty. I think i should do some other things to fill the output folder with useful xilinx project that contains all other sub modules. How can i fill output folder?


Thanks.
  • Logged

arnaudNL February 05, 2014, 06:17 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


The 4FM Getting Started Guide is covering that; You've got to use StellarIP in order to create the ISE project in the output folder.


Thanks,
Arnaud
  • Logged

arnaudNL April 01, 2014, 08:01 AM (#2)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016