I have an FMC126 interfaced to a KC705 board. I am attempting to use the sample program from 4 DSP to output data via ethernet, but the device is not found. Steps I take to test include:
1. Program the xc7l325t device with the file 253_kc705_fmc126.bit using Impact. Do not program the other device listed, xc2c64a.
2. Attempt to read the device using the 4DSP command line program. See attached png. for the error.
After I program the device, the following ethernet lights illuminate: Half Duplex, 100 Mbps, RX