Topic: Demo project for FMC116 with ML605  (Read 5087 times)

MCLbu August 09, 2013, 06:43 PM

  • Member
  • *
  • Posts: 14
Hello,
I am trying to get started with the FMC116 on a ML605. I have installed all packages and licences. I am currently lost between all documentation and multiple different software packages. I am wondering if you have a simple demo project(s) that I can load and run and learn how to configure and read data from the ADC. Any documentation on a step by step guide will be helpful.


Thank you,

arnaudNL August 12, 2013, 04:30 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


The software sources controlling the FMC116 is to be found under:


C:\Program Files (x86)\4dsp\FMC Board Support Package\Refs\Software


The firmware sources should have been extracted under:


C:\Program Files (x86)\4dsp\Common\Firmware\Extracted\


The precompiled software is installed under:


C:\Program Files (x86)\4dsp\FMC Board Support Package\Bins


The precompiled firmware is installed under:


C:\Program Files (x86)\4dsp\Common\Firmware\Recovery


Chapter 8 of the 4FM Getting Started guide covers using our boards on Xilinx dev boards:


C:\Program Files (x86)\4dsp\4FM Core Development Kit\Documentation


The FMC116 software will acquire samples from the FMC116 and save them to the hard disk as ASCII files, this is the simplest demo for this product.


Best Regards,
Arnaud

MCLbu August 22, 2013, 04:35 PM (#2)

  • Member
  • *
  • Posts: 14
Thank You.

arnaudNL April 01, 2014, 08:04 AM (#3)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.