These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: data acquisition on a Kintex 7 DSP Kit with "FMC150"  (Read 5086 times)

nams June 10, 2013, 08:57 PM

  • Member
  • *
  • Posts: 1
I have tried data acquisition on a Kintex 7 DSP Kit with "FMC150" using System Generator for DSP 14.3

but it seems like there is some problem on the IN_A channel of FMC150 card. IN_B channel is OK

there are unwanted peaks with acquired data of IN_A channel
 
is this hardware malfuction or misconfiguation?
 
please refer below attachments. thank you
  • Logged

arnaudNL June 11, 2013, 06:06 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


It look like you are facing timing issue in your FGPA design. Your best bet would be to contact Avnet which are actually selling the DSP Kit as well as providing technical support for this specific design.


Best Regards,
Arnaud
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016