Topic: Errors in FMC176 User Manual  (Read 3699 times)

Stefan_G March 19, 2013, 03:05 PM

  • Member
  • *
  • Posts: 2
I just wanted to let the community know that there are some errors in FMC interface pin-out table located in Appendix A of the r1.1 (February 2013) FMC176 User Manual .  I'll let the 4DSP folks clarify what they are.
 
Best,
Stefan

arnaudNL March 20, 2013, 05:58 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Stefan,
Thank you for you valuable feedback. Are you referring to the revision 1.1 document part of our current material? I can see that there was an update on FMC176/FMC230 user manuals:
FMC_TO_CPLD pins pairs were swapped 1 and 2 as well as 3 and 4.
CLK_DIR is unconnected.
Could you please indicate if this is the errors you are referring to?  I am attaching revision 1.1 manual to this post.
Best Regards,
Arnaud

Alexandru June 04, 2013, 02:23 PM (#2)

  • Member
  • *
  • Posts: 3
Is there an error in the pinout on net CLK0_M2C_N and CLK0_M2C_P?
Are signal CLK_TO_FPGAN/P on pins H4 and H5 actually on D4 and D5 of the FMC connector?

Kyu June 06, 2013, 03:27 PM (#3)

  • Member
  • *
  • Posts: 154

Alexandru,


CLK_TO_FPGA pins are connected correctly to H4 and H5 of the FMC connector. D4 and D5 are connected to GBTCLK0 (which is ref_clk in the firmware). We will update the GBTCLK pins.


Thanks,
Kyu