Products > FMC176

“\275_kc705_fmc176\output is empty

(1/1)

abesabet:
the following document
CD275 KC705+FMC176
FMC176
Reference Firmware
For KC705

stated the following state men

4.1 Setting up the simulation
In order to setup the simulation, perform the following steps:
- Start with the creation of the ISE project. Refer to the StellarIP section in the 4FM
Getting Started Guide.
- Use ISE to open the project from “\275_kc705_fmc176\output\ kc705_ fmc176”.
problem is
“\275_kc705_fmc176\output is empty and there is no project

arnaudNL:
Dear Sir,
Have you actually ran StellarIP? StellarIP is creating the Xilinx project and the simulation environment.
Best Regards,
Arnaud

Navigation

[0] Message Index