Topic: “\275_kc705_fmc176\output is empty  (Read 8437 times)

abesabet February 21, 2013, 06:33 PM

  • Member
  • *
  • Posts: 5
the following document
CD275 KC705+FMC176
FMC176
Reference Firmware
For KC705

stated the following state men

4.1 Setting up the simulation
In order to setup the simulation, perform the following steps:
- Start with the creation of the ISE project. Refer to the StellarIP section in the 4FM
Getting Started Guide.
- Use ISE to open the project from “\275_kc705_fmc176\output\ kc705_ fmc176”.
problem is
“\275_kc705_fmc176\output is empty and there is no project

arnaudNL February 22, 2013, 07:04 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,
Have you actually ran StellarIP? StellarIP is creating the Xilinx project and the simulation environment.
Best Regards,
Arnaud