These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: Simulator in ISE 14.4  (Read 5378 times)

rvincentzio February 19, 2013, 08:34 PM

  • Member
  • *
  • Posts: 29
I am following the steps of 4FM Getting Started Guide. The section 2.4, Software Requirements (Modelsim...) talks about configuring the Modelsim. In the ISE 14.4 that comes with my KC705 the simulation lib. compilation wizard is under the ISE Design Tools, 32 bit tools. But when I start it I am getting the attached tab. Please advice how to proceed with the configuration.
  • Logged

arnaudNL February 22, 2013, 07:32 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


We are phasing out modelsim because its price is ridiculous. For instance, the simulation is now done in ISIM typically for FMC30RF.


You can check the constellation documentation found in the firmware source code. There is the steps required for ISIM simulation described in there.


Best Regards,
Arnaud
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016