From the 4FM Getting Started Guide V4.3 pg. 19: "Note that devices communicating over Ethernet as the ML605 cannot be controlled by this software." and pg. 21, pg. 23, pg. 24 "Devices communicating over Ethernet as the ML605 are not supported by this plug-in!" I'm not sure how to interpret these statements. Does this mean that just the software/plug-in does support the ML605 using PCIe as the interface? Or is there no support using the ML605 with the PCIe interface at all?
For PCIe, I'm assuming that the ML605 FPGA must be first be programmed before the PC with the ML605 installed in a PCIe slot is powered on. This means either the ML605 FPGA must be programmed via JTAG by another computer running iMPACT or the image must be uploaded to the ML605 flash so the ML605 can automatically program the FPGA from flash when the PC is turned on. Looking further on pg. 38-39, it mentions using the 4FM GUI Control application to upload the firmware into FPGA A or FPGA B. Is this referring to 4DSP carrier boards? I don't see any mention of the ML605, so is it supported? Also, how do I bring up the "Registers/Update" plug-in? Am I not seeing any plug-ins because "Active Devices" is always "No device found" b/c the GUI is not connecting to the device? How do I fix this?